|
CE-mark certified
3 3/4 digit,4000 count display with bar-graph (Frequency
range:19999 counts)
Accurate RPM measurements for 2 and 4 stroke engines with
1 to 8 cylinders using inductive pick up.
ms-Pulse Width function to test on-time of PFI and TBI type
injectors.
Duty cycle and direct DWELL reading.
4 steps adjustable triggers on 1 to 8 cylinders.
Temperature measurement up to 1,370°C (2,498°F).
Data Hold, MIN/MAX/AVG, and Relative mode.
Backlit display.
Auto power off.
High-Impact Over moulded case.
Click
here to download the manual
$325.00 inc GST
|
CE-mark certified
4-4/5 digit, 50000 count (primary) and 99999 count (secondary)
dual display bar-graph. (Frequency range : 99999 counts).
Closed case calibration through the phototronic RS-232C
serial port.
Accurate RPM Measurement for 2 and 4 stroke engines
with 1 to 12 cylinders using the inductive pick up.
ms-Pulse Width function to test on-time of PFI and TBI type
injectors, idle air control motors and electronic transmission
controls.
Duty cycle and direct DWELL reading for electronic fuel
injection..
4 steps adjustable triggers on 1 to 12 cylinders, either
2 or 4 stroke for outboards,motorcycles etc.
Temperature measurement up to 1,300°C (2,372°F).
O2 sensor test for quick diagnosis and simulation of the
complete O2 sensor.
Ground test to locate bad ground, voltage drops, intermittent
connections or any source of high resistance in an electrical
circuit.
Charging system test to diagnose the battery and the alternator.
Battery drain test to measure battery current when ignition
off.
Auto Hold,50ms high speed MIN/MAX/AVG, and relative mode.
1 ms peak mode
Memory store and recall.
Backlit display.
Auto Power off
High-Impact moulded case.
Click
here to download the manual
Delivered with:-
1 x No. 1 pickup clamp
3 x probes incl alligator
clamp
1 x temp probe
1 x manual
$375.00 inc GST
|
CE-mark Certified.
4-4/5 digit, 50000 count (primary) and 3-4/5 digit, 5000
count (secondary) dual display with 26 segments bar-graph.
(Frequency range : 99999 counts).
Closed case calibration through the phototronic RS-232C
serial port (compatible with a USB port of a PC by using
the RS-232C to USB adaptor supplied).
Battery leakage current & Cranking current tester.
Electric Motor tester for electric vehicles.
ECU tester to measure the current drain when the ignition
is turned off.
PFI/TBI Injection On-Time measurement function.
Ignition Peak Voltage measurement mode.
Ignition Burn Voltage measurement mode.
Ignition Burn Time measurement mode.
Accurate RPM measurements for 4- and 2- stroke automotive
engines with 1 to 12 Cylinders.
Duty Cycle and direct DWELL reading for electronic fuel
injection, feedback carburetors, and ignition systems.
4 steps adjustable triggers on 1 to 12 Cylinders, either
4- or 2- Cylinder for outboards, motorcycles and conventional
engines.
Measure temperature of fan switch and catalytic convertors
up to 1,300°C (2,372°F).
Auto Hold, 50ms high speed MIN/MAX/AVG, and Relative mode.
Memory store and recall (20 locations).
Backlit display.
RRS-232C phototronic serial port (This RS-232C port is interfaceable
with a USB port of a PC by using the RS-232C to USB adaptor
supplied).
High-Impact moulded case.
EN-61010-1; CAT III 1000V and CAT IV 600V rating.
Click
here to download the manual
Delivered with:-
1 x 0-30a current clamp
1 x 0-1500a current clamp
1 x temp probe
1 x communication software
cd
1 x rs232 connection
1 x rs232 - usb cable
1 x No 1 pickup clamp
1 x kv lead (secondary
ignition)
2 x probes incl alligator
clamp
1 x manual
$945.00 inc Gst
|
